Scale analytical method parameters to your preparative column. Calculate key method parameters (like flow rate, injection volume, or gradient) for your preparative column. The calculator also accounts for differences in particle size, column lengths and system dwell volumes to ensure seamless scale up.
Scale preparative method conditions to your analytical column. Calculate analytical method conditions based on an established preparative method. This can be helpful when investigating analytical columns with alternate dimensions and particle sizes to improve screening throughput.
Calculate column capacity and total number of injections. Use the column capacity and injection number to determine the perfect size preparative column for your purification campaign.
Calculate time and mobile phase consumption. Use these values to manage solvent inventory and instrumentation scheduling.
Using the prep scaling calculator is simple
Use the “Switch method” button to set the scaling direction (i.e., analytical to preparative versus preparative to analytical).
Enter the required fields (indicated by *) to calculate your scaled method.
Click on the
More information
for more information.
Input
Output
Required field
Note: Preparative to analytical scaling calculations do not take dwell volume into consideration.
Name of each chromatographic instrument (e.g., “1260 Infinity II Preparative LC” or “1260 Infinity II Analytical LC”)
More information
Minimum instrument flow rate
More information
Maximum instrument flow rate
More information
Volume from the mobile phase mixing point to the column inlet. Learn more
More information
Time required for the autosampler to complete one injection cycle
More information
Solvent name (e.g., “Water + 0.1% formic acid”)
More information
Solvent name (e.g., “Acetonitrile + 0.1% formic acid”)
Column Information
More information
Stationary phase name (e.g., “ZORBAX SB-C18”).
More information
Column particle size
More information
Column internal diameter
More information
Column length
More information
Method flow rate
This value exceeds the maximum flow rate. The gradient table will be calculated using the maximum flow rate.
More information
Method injection volume
More information
Estimated concentration of the target compound in the sample
Override preparative flow rate
More information
Select “yes” to scale the analytical gradient program to a user-defined preparative flow rate; select “no” to use the preparative flow rate scaled from the analytical flow rate
Use the following step gradient method to determine the dwell volume of a chromatographic system.
Prepare solvent A: 100 % water
Prepare solvent B: 99 % acetonitrile and 1 % acetone
Replace the column by a restriction capillary 0.005" id (0.12 mm id) × 750 mm.
Set the detection wavelength to 263 nm.
Run a step gradient at 4 minutes from 10 to 90 % B at a flow rate of 2 mL/min.
Note that when using sample loops with volumes larger than 5 mL, the flow rate needs to be increased. A good compromise is to keep the flow rate equal to the loop size.
Calculate the time difference (tdwell) between the programmed gradient and the obtained signal curve at 50 %.
vdwell can be calculated from vdwell = tdwell × f
Questions? Our preparative LC team is here to help.
